Shop

Application

Surface Considerations:

• Before commencing grouting, the adhesive bed must be set.
• The joints must be clean of all adhesive residue, dust or debris.
• Lightly sponge the tile surface to remove dust & dirt.

Mixing:

The entire contents of PART A and PART B should be poured into a clean mixing vessel and mix to a uniform consistency. Slowly add PART C until the required slump free smooth paste is obtained. Immediately pour the mixed grout onto the working area.

(WE STRONGLY SUGGEST TO MIX THE NECESSARY PORTION ONLY AND USE IT WITHIN 30 MIN)

Application:

• Using a hard rubber grout float, compact the EPOXY GROUT into the joints ensuring that they are completely filled. Work in small areas and remove as much excess from the tile/stone surface as possible. Strike off excess materials diagonally to the grout lines.

Cleaning

Remove excess grout from the face of the tiles with the edge of the grout float. Hold the float at a 90° angle and pull it diagonally across the joints and tile to avoid pulling out the material.

Initial Cleaning:

After 30-45 min of the application of the grout scrub the surface of the tile & joint with clean water and scrubber provided to remove any excess grout. Then take a clean thick white towel and drag across the tile to remove any residue.

Final Cleaning:

Within 24 hours do a second cleaning with normal soap detergent to remove any haze from the tile.