GROUTS BY MYK LATICRETE
SP-100 Tile Joint is a Stain Resistant, Water Resistant & Germ Resistant grout for Floor & Wall. SP-100 Tile-Joint is suitable for ceramic tiles, vitrified tiles, marble and stone, especially in stain prone areas such as kitchens and washrooms.
Areas of Application:- Kitchens, bathrooms, swimming pools, fountains, water bodies, hospitals,operation theatres, sterilization rooms, restaurants, cafeterias, light industrial applications and high traffic areas.
Available in a range of more than 36 colours.
Unit
Before starting to grout, remove debris in grout joints and lightly sponge the tile surface to remove dust and dirt. Do not clean tiles with acid cleaners. In case acid cleaners were used to clean the tiles, ensure to wash the area with plenty of water before commencing grouting.
Empty entire contents of SP-100 Stain free Grout Part “A” and Part “B” container into a clean mixing pail.
Mix with a margin trowel or a slow speed drill mixer until liquids are completely blended. Add at least ¾ of SP-100 Tile joint Part “C” Filler Powder and mix to a uniform consistency keep adding remaining filler powder as much needed and mix to achieve a stiff mix to work into the joints.
(WE STRONGLY SUGGEST TO MIX THE NECESSARY PORTION ONLY AND USE IT WITHIN 30 MIN)
SP-100 is a factory proportioned kit with Resin (Part A), Hardener (Part B), and colored filler powder (Part C).
SP100 must be applied evenly on the tile / mosaic using a hard rubber squeeze / grout float, press the grout firmly into the joints in a continuous manner, leaving it flush with the tile edge. Hold the float at a 90° angle and pull it at a 45° angle diagonally across the joints and tile to avoid pulling out the material. Work in small areas to have better control on removing the excess grout from joints and surface by moving the squeeze diagonally to the grout lines. It is recommended that a test be carried out in advance before laying to ensure the surface can be properly cleaned.
After 30-45 min of the application of the grout scrub the surface of the tile & joint with clean water and scrubber provided to remove any excess grout. Use the sponge in circular motion to get optimum results. Then take a clean thick white towel and drag across the tile to remove any residue.
Within 24 hours do a second cleaning with normal soap detergent to remove any haze from the tile.
Surface ready to use:
Light foot traffic approximately 2 – 3 days
Heavy foot traffic approximately 3 – 4 days
• Ceramic tile
• Vitrified tile
• Glass Mosaic Tiles
• Granite
• Marble
• Metal tiles
• Engineered Stones
• Precast Terrazzo tiles
Suitable for joints of 2mm – 12mm
Please refer the Grout calculator as it depends
on the tile size, joint width and depth.
