GROUTS BY MYK LATICRETE
L600 SERIES UNSANDED GROUT A carefully prepared blend of Portland cement, graded aggregates, fortifiers and colour – fast pigments, it is designed for joint width 1mm to 3mm, for porous & absorbent type tiles, non-vitreous clay tiles, and marble & glazed wall tiles. Suitable for internal and external applications
For best results use with L1776 Grout admix.
Cement based colour Grout Use L600 series (available in a range of colours)
Unit
Mix the L600 grout powder with L1776 Latex Admix,(1kg bag : 3.75 ml) mix only enough that can be used in 30 min or less. Clean up immediately before beginning next mix.
When applying, the grout joints should be free of dirt, debris or tile spacers. Sponge or wipe dust/dirt of tile faces and remove water standing in joints. Pack joints full and free of voids with rubber grouting float. Remove excess grout from tile faces using edge of rubber float and diagonal strokes (at 45° angle to direction of joints). When the joints have set, use a moist sponge to remove excess grout from the tile and joint. Use minimal water for clean up. Final clean up to remove any grout haze should be carried out within the next 12 – 24 hours.
Mixing Ratio: L600 series Unsanded Grout : Water or L1776 Admix (1kg bag : 3.75 ml)
• Ceramic tile
• Vitrified tile
• Glass Mosaic Tiles
• Granite
• Marble
• Agglomerates (Engineered Stones)
• Precast Terrazzo tiles
• Bricks
Please refer the Grout calculator as it depends on the tile size, joint width and depth.
