Contact Info

img

ARDEX ENDURA PLATINUM STAR PLUS GREY

(0)
1,150.00

ADHESIVES BY ARDEX ENDURA

PLATIMUN STAR PLUS GREY High polymer modified, grey coloured adhesive formulated with enhanced properties of slip resistance, flexibility and extended open time necessary for fixing large format tiles, slim tiles and stable natural stones on wall/floor in interior/exterior situations.

Platinum Star Plus (Grey) is fibre reinforced to increase the flexural and bond strength of the adhesive and to impede the crack propagation in the composite material.

Areas of Application:- Designed especially for dry/wet areas of interior and exterior floor and wall. Installations of all types of ceramic tile, vitrified tiles, mosaics and small format natural stones over concrete and on a variety of cement-based substrates. Can also be used as tile on tile. Can be used up to 15 mm bed thickness

Unit

20KG

Application

Surface Preparation:

New Concrete Bases: Before commencing tiling, ensure that bases have been allowed to air dry for at least 4 weeks.

New Cement Sand rendering: Before commencing tiling, allow plastered surface to air dry for at least 2 weeks (3 weeks for swimming pools).

Existing Concrete/Screed Bases: Cut out all loose or hollow portions and make good with a 1:3 cement:sand mortar applied over a slurry bonding coat* and let it cure and dry for 7 days.

Ceramic/Vitrified & Fully Vitrified Tile/Terrazzo/Hard Natural Stone Bases: Check that existing finish is firmly adhering to the base. Remove any loose or hollow sounding tiles.

Mixing:

Place clean, potable water into a clean mixing bowl. Add PLATINUM STAR PLUS GREY powder into the mixing bowl. Use approximately 5.5 – 6L of water for 20 kg of powder.

Mix by hand or with a slow speed mixer to a smooth, trowelable consistency. Allow adhesive to slake for 5 minutes. Adjust consistency if necessary. Remix and apply with the proper sized notched trowel.

Proportion:

Approximately 1 bag of PLATINUM STAR PLUS GREY with 5.5-6 ltrs of water. Adjust quantity of liquid to obtain proper consistency.

Installation:

Apply adhesive to the substrate with the flat side of the trowel, pressing firmly to work into surface. Comb on additional adhesive with the notched side. Use the proper sized notched trowel to ensure full bedding of the tile. Spread as much adhesive as can be covered with tile in 10 minutes.
Back butter large format tiles (> 12”x12”) to provide full bedding and firm support. Place tiles into wet, sticky adhesive and beat in using a beating block and rubber mallet to imbed tile and adjust level. Check adhesive for complete coverage by periodically removing a tile and inspecting bedding adhesive transfer onto back of tile. Use of spacer is recommended to provide grout joints between tiles / stones. The joint width shall be as per the recommendation of architect / engineer. Remove the spacers when the adhesive is set firm.
If adhesive is skinned over (not sticky), remove and replace with fresh adhesive.

Grouting:

Grout installation shall be commenced after a minimum of 24 hours curing time at 70°F (21° C).
For maximum stain resistance EPOXY GROUT is recommended

Substrate

  • Concrete walls & floor
  • Cement sand screed
  • Cement sand render
  • Pre-fabricated concrete walls
  • Unglazed tiles*
  • Hard natural stones*
  • Glazed tiles* (vitrified and ceramic tiles)
  • Mosaic tiles*

*The surface should be abraded (roughened) and cleaned before installation.

Coverage

Approx. 50-55 sq. ft. per 20 kg bag with a ¼” x ¼” (6mmx6mm) square notch trowel for a bed of 3mm.

Coverage will vary depending on trowel notch size, type and size of tile and substrate smoothness and evenness.